Aquatherm 16204-10 User Manual

INDUSTRIES INCORPORATEDMANUAL CONTENTSThis manual provides a detailed step-by-step pro-cedure for the installation of an AquathermIndustries solar po

VACUUM RELIEFVALVEFEEDOUTLETENDCAPENDCAPENDCAPVACUUM RELIEFVALVEVACUUM RELIEFVALVE10Figure 12Manual Control of SystemTo test collector operation, foll

11remove the vacuum relief valve(s) and replace it with andend cap. Relocate a vacuum relief valve to a position inthe inlet piping which is at a heig

SOLARCOLLECTORSEND CAPOUTLET LINETHERMOMETER(optional)ISOLATION CHECKVALVE (optional)HEATER(optional)HEATER BY-PASSBALL VALVE (optional)HEATEDWATER

2MOUNTINGCOMPONENTSDIAGRAMMOUNTING COMPONENTSThis section provides descriptions and part numbers of theAquatherm Industries Installation Kits required

Aluminum Mounting Bracket & Header Clamp Assembly3Hold-Down Strap is required to secure collectors tothe counting surface. Use strap 10035-1 (54’)

VACUUM RELIEF VALVENote: This end of row lower thanopposite end. See instruction 2.FLOWINLET(from pool)OUTLET(to pool)FLOWENDCAPINLET OUTLETVACUUMRE

51) Determine the position of the last outlet header hold-down bracket for the row of collectors. Mark this point on theroof. The collector outlet hea

67) Proceed to the lower chalk line previously snapped onthe roof for the hold-down strap brackets. Mark a hole 2”(5cm) to the side of the first colle

SOLARCOLLECTORSEND CAPOUTLET LINETHERMOMETERS(optional)ISOLATION CHECKVALVE (optional)HEATER(optional)HEATER BY-PASSBALL VALVE (optional)HEATEDWATER

8Manual SystemsSome systems can employ a manual control valve to con-trol the flow of water thru the solar collectors, although thismay reduce the ove

VACUUMRELIEFVALVESTEEELBOWENDCAPELBOWSRETURN FROMHIGHEST POINTTEEENDCAPSINLET(from pool)OUTLET(to pool)9Figure 11DIVIDEDSYSTEMASSEMBLYON ROOFSpecial S